CYP IP-CS7, Operation Manual, Page: 22 / 36

22
attempt to obtain proper configuration information from the local DHCP
server. If no DHCP server is available, or the user wishes to configure the
network settings manually, please set the unit to “Static IP” mode and
enter the information as appropriate for your local network. Press “Save”
to activate the changes.
Login & Logout
This window provides Login, Logout, Change Password, and Reset
buttons as well as a button to start the Setup Wizard.
Firmware Upgrade
It is possible to update the firmware of this unit as well as to update the
firmware of detected Transmitters and Receivers. The number of currently
detected Transmitters and Receivers is also listed here.
To update the unit's firmware, or the firmware of detected Transmitters
or Receivers, click the “Choose File” button beneath the appropriate
device type (IP Master Controller, Transmitter, or Receiver) to open the
file selection window and then select an appropriate firmware update
file (*.bin format) located on your local PC. After selecting the file, click
the “Upgrade” button beneath the appropriate device type to begin
the firmware update process. Once the firmware update process has
completed each updated unit will reboot.
i
The firmware update process can take several minutes, please do not
power the units off once the process has begun.
6.8.4 Setup Wizard
Pressing the “Wizard” button will start the step by step Setup Wizard.
It will also clear the unit’s stored Transmitter/Receiver history, Presets,
and Groups. The following 4 windows will then be presented, in order,
to simplify the initial setup of a new Video over IP routing installation.
Prior to pressing the “Finish” button on the final page of the wizard, it is
possible to move freely between all 4 steps of the Setup Wizard to make
additional changes to the configuration. Once “Finish” has been pressed,
the changes will be committed to all involved units and they will reboot.
Transmitter Setting
This wizard step provides a way to control the detailed settings of each
detected Transmitter. First, click on the “Scan” button to check the LAN
1 network for all available Transmitters. Once the list is populated with