![background image](http://html1.mh-extra.com/html/cybex/autoview-200/autoview-200_installer-and-user-manual_2703690018.webp)
AutoView 200 Installer/User Guide
12
Convention
Key Sequence or Value
Enter Command Mode:
<CM>
1. Press and hold down the ‘Num Lock’ key.
2. Press and release the minus (-) key on the numeric keypad.
3. Release the ‘Num Lock’ key.
Note: For alternate hot-key sequences, see ‘System Control &
Maintenance’ later in this chapter.
<Enter>
Press the ‘Enter’ or ‘Return’ key. The
<Enter>
command is used to
execute an instruction and exit from Command Mode.
Addr
The letters over the push-buttons on your AutoView 200 are your
PCs' addresses. Enter the letter, A-H, for the PC you're selecting. For
cascaded systems, enter the address of the base unit first.
Example: You have an AutoView 200 unit cascaded from channel
B of your base unit. To access the PC at channel C of this second
(cascaded) unit, enter
BC.
<ESC>
Press the ‘Escape’ key. The
<ESC>
command is used to exit
Command Mode without executing an instruction.
The following notational conventions appear throughout this chapter to
illustrate commands for operating the AutoView 200. Whenever you see
one of the symbols listed on the left side of the table, substitute the
corresponding steps or values listed on the right side of the table.
Keyboard Control