AutoView 200 Installer/User Guide
6
Connecting your Remote Peripherals
4. Plug a standard Category 5 Unshielded Twisted Pair cable (up to 500
feet) into the RJ-45 style modular jack on the rear of the AutoView 200.
Cybex C5T or Cybex P5T cable is strongly recommended to achieve
best performance and maximum distance. If you use a different
Category 5 cable, make sure it is terminated to the EIA (TIA) 568 B
standard, commonly used for 10BaseT Ethernet.
5. Route the Category 5 cable to the location where you intend to
place the secondary monitor, keyboard and mouse.
6. Place the LongView Receiver near the monitor and connect your
monitor, keyboard and mouse to the connectors on the rear of the
Receiver just as you would connect them to your PC. Make sure you
connect your monitor’s power supply to appropriate electrical outlets.
(Please note that the
connector on the rear of the Receiver is
not used in an AutoView 200 configuration. Do not connect any-
thing to the
connector on the rear of the Receiver.)
7. Connect the Category 5 cable to the modular jack on the rear of
the Receiver.
8. There are two power ports for the LongView Receiver. One on the
back of the AutoView 200 and one on the Receiver. Connect the
circular power plug from the wall mount power supply to either
power port, whichever is most convenient for you. Then plug the
power supply into a convenient electrical outlet. Verify that the
Receiver’s POWER light is now lit.