
31
Appendix B-Power Device Network Utility
Launch Program
To launch the Power Device Network Utility and get started, select Programs
from the Start menu in Windows and locate the new folder and icons for
Power Device Network Utility. Select Power Device Network Utility from the
program folder (Shown in Figure 5).
Step 5. Select
Finish
to finalize the installation (Shown in Figure 4).
Figure 4
Figure 5. Power Device Network Utility
Getting Started
The Power Device Network Utility scans the network for devices with MAC
addresses that match CyberPower network hardware. Once found, the
device(s) can then be figured with a specific IP address, subnet mask, and
gateway address. This allows the device(s) to function properly on the
network and interface with CyberPower Management Console.
Step 1. Select the appropriate ATS PDU from the Equipment List (Shown in
Figure 6).
Figure 6. Equipment List
Note:
If the ATS PDU does not appear on the list, click the
Refresh
button to rescan the network. If it still does not appear, ensure
that the ATS PDU is turned on and is installed correctly.
Pressing
Stop
will cancel the scan/refresh process.
Note:
If your computer has a software firewall installed, you may see a
Windows Security Alert message (Shown in Figure 7).
In Windows XP SP2, the default firewall alert message is shown as
Figure 7. You need to allow the Power Device Network Utility access
through the firewall. Click
Unblock
to allow access.