•
Safety Gear
2.2 Unpacking
NOTE: Always observe ESD precautions when handling circuit boards!
Before opening package(s), inspect the shipping box(es) and report any damage to the
shipping carrier. Your package was insured and the shipping carrier will be responsible
for any damage to the equipment. Unpack and compare the contents against the
packing slip and inspect all for damage. Report any damage to the units or missing
components to your Carlson Wireless customer service representative.
Included with your purchase are:
•
The ‘Quick Start Guide’ helps you become familiar with your system
•
The Carlson Wireless Product CD (containing the user manuals, back- up
configuration software and other needed items!)
•
(2) Test Antennas for bench testing
•
One Serial Interface Cable per unit to connect to the GUI
•
Mounting Hardware (optional)
•
Optional Power Supplies, if ordered, will be pre-installed in the enclosures
•
Optional Surge Protectors (RF and phone lines)
•
Antennas
(optional)
•
Optional Batteries, if ordered, will be shipped outside the enclosure to prevent
damage.
2.3 Bench Testing Instructions
Before going into the field, set up the Trailblazer units on your bench so you can become
familiar with their operation, configuration and verify their functionality. Each system is
shipped with a handy, full-color “Quick Start Guide” for simplified step-by-step
instructions for bench testing. The following section will provide you with the same
information in greater detail.
2.3.1 Setting up Your Trailblazer on the Bench
Set your units next to each other and attach the included test antennas to the ‘N’ female
connectors on the enclosures as shown below. The units may not achieve an RF
connection without these little antennas.
Figure 2: Test Antennas
Test Antennas
Trailblazer Installation and User Manual
9
