![background image](http://html1.mh-extra.com/html/curtis/1yansapr/1yansapr_installation-and-owners-manual_2699090018.webp)
CAB INSTALLATION
18 of 29
STEP 20: (WIPER ARM AND BLADE)
20.1
Turn on the wiper motor briefly, then turn back off. This
will make sure the motor shaft is in the correct parked
position.
20.2
Pre
-
assemble the wiper arm and wiper blade.
20.3
Install the wiper arm onto the wiper motor so that the
wiper is positioned as shown in figure 20.3. Tighten the
set screws.
Tools required
2.5mm Allen Wrench
20.4
Adjust the length of the wiper arm as long as possible
while still clearing the outer cap nut for the windshield
latches. Turn on the wiper to check proper operation
and to make sure the blade does not contact the
windshield hinge at the top.
Fig. 20.3 (Wiper Arm and Blade)
Set Screw
Set Screw
Fig. 19.5 (Connect Harness to Alternator)
Fig. 19.4 (Connect Ground Terminal)
STEP 19: (FINISH WIRING CONT
’
D)
19.4
Connect the ground terminal to the vehicle bracket
shown in Figure 19.4.
Hardware Used
Qty
#10
-
32 x
1/2”
Phillips Screw
1
#10
-
32 Nut
1
Tools required
#2 Phillips screw driver
3/8”
Socket or Wrench
19.5
Connect the supplied fuse harness ring terminal to the
positive post on the back of the alternator. See Figure
19.5. Connect the red wire from the cab power harness
to the other side of the fuse harness. Coil up excess
harness and wire tie in place.
19.6
Refill coolant, connect battery, check system operation.
Ground Terminal
Positive Post