CAB INSTALLATION
19 of 29
STEP 21: (UNDER SEAT FILLER)
NOTE: Open and or remove the glass rear panel for
easier access.
21.1
Pre
-
install the supplied Velcro to the under seat filler.
Leave the release tape on until the filler is in place.
21.2
Tip the seat forward and set the filler in place starting
with the slits for the control levers on the left side. See
Figure 21.2. Do not stick Velcro yet.
21.3
Fold and tuck the left rear corner under the rear leg.
See Figure 21.3. Align the inner corner and inner edge
to the rear leg and apply the Velcro.
21.4
Pull the left rear flap back and secure to the rear fender.
See Figure 21.4. The flap should run close to the
ROPS and turn inward to create a water channel.
21.5
Repeat steps 21.3 and 21.4 for the right rear corner.
21.6
If the rear panel was removed for easier access, re
-
install it at this time. Secure the rear of the filler to the
glass rear panel. See Figures 21.6a and b.
21.7
Finally, ensure full movement of the control levers and
secure the front half of the under seat filler. Do not
cover any decals.
Note:
Ensure the transition noted on Figure 21.3 prevents
water intrusion. Adjustment may be necessary to keep
water from running in.
Fig. 21.2 (Set Filler In Place)
Fig. 21.3 (Secure Rear Left Corner)
Fig. 21.4 (Secure Rear Flap)
Fig. 21.6a (Secure Filler to Rear Panel)
Fig. 21.6b (Secure Filler to Rear Panel)
Control Lever Slits
Align Corner
Align Edge
Across to
Side Frame
Ensure No Gap
Water Channel
Note Transition
