CAB INSTALLATION
8 of 29
STEP 8: (WINDSHIELD)
8.1
Check the windshield support for squareness to the side
frames and tighten the two screws to 12.5 ft.
-
lbs.
8.2
With assistance, set the windshield up to the side
frames and secure it to the windshield support using the
hinge spacers and hardware. See Figure 8.2. Leave
hardware loose.
Hardware Used
Qty
5/16
-
18 x
1.5”
Flat Head Screw
4
5/16
-
18 Hex Nut
4
Tools required
#3 Phillips screw driver
½
”
wrench or socket.
8.3
Close the windshield while lifting up on the bottom edge.
Tighten hinge hardware.
Caution: The windshield
hinges are plastic components. Do not overtighten
the flat head screws. Torque to 7 ft.
-
lbs. max.
Tools required
Torque Wrench
8.4
Ensure the windshield latches function properly and the
windshield pivots open.
8.5
Remove the over
-
tightening caution decal from the top
of the windshield.
Fig. 10.1 (Install Roof)
Fig. 8.2 (Attach Windshield)
Fig. 9.1 (Windshield Wiper Motor)
STEP 10: (ROOF)
NOTE:
If installing a Backhoe Compatibility Kit, refer to the
Backhoe Compatibility Kit Installation Instructions for the
roof installation and then proceed to step 11 of these
installation instructions.
10.1
With assistance, set the roof on top of the cab. Loosely
secure with sealing washers on the (8) screws through
the top of the roof. See Figure 10.1.
Hardware Used
Qty
5/16
-
18 x
3/4”
Hex Head Screw
8
5/16”
Sealing Washer
8
5/16
-
18 Hex Nut
4
Tools required
1/2”
Wrenches and/or Sockets
5/16
-
18 Flat
Head Screws
5/16
-
18
Nuts
Hinge Spacer
STEP 9: (WINDSHIELD WIPER
MOTOR)
9.1
Mount the wiper motor to the windshield. See Figure
9.1.
NOTE:
Do not install the wiper arm and blade at this time.
Once all the wiring is complete and power is restored, it
can be turned on and off to ensure that the wiper arm
will be parked in the correct position once it is attached
at a later step.
Hex Nut
Plastic Washer
Rubber Washer
Large Collared
Bushing (inside)
1/4
-
20 x
5/8”
Screw
1/4”
Int. Tooth Lock Washer
Small Collared
Bushing (Inside)
Rubber Washer
Steel
Washer
Cap Nut
(8) 5/16
-
18 x
3/4”
Screws
and Sealing Washers
5/16
-
18 Nuts
