CAB INSTALLATION
12 of 29
STEP 15: (CAB WIRING)
15.1
Attach the main power wire harness to the windshield
wiper connector, and secure to the windshield support
using a P
-
clip and hardware. Make sure there is
enough slack to fully open the windshield. See Figure
15.1.
Hardware Used
Qty
#10
-
32 x
1/2”
Pan Head Screw
1
#10
-
32 Hex Nut
1
Tools required
#2 Phillips Screw Driver
3/8”
Wrench or Socket.
15.2
Run the harness along the windshield support and
down the side frame. Secure it with (2) more P
-
clips
and hardware. See Figure 15.2. Connect the harness
to the heater switch.
Hardware Used
Qty
#10 x
3/4”
Self
-
Drill Screw
2
Tools required
#2 Phillips Screw Driver
15.3
Snap in the heater switch into the rectangular cutout in
the cowl and connect the harness. See Figure 15.3.
Secure harness to side frame just above the cowl using
a P
-
clip and self
-
drill screw. Use a cable tie to loosely
secure the harness wires together as shown.
Hardware Used
Qty
#10 x
3/4”
Self
-
Drill Screw
1
Tools required
#2 Phillips Screw Driver
15.4
Secure the harness with one more P
-
clip halfway
between the two P
-
clips on the side frame.
Hardware Used
Qty
#10 x
3/4”
Self
-
Drill Screw
1
Tools required
#2 Phillips Screw Driver
15.5
The rest of the harness runs down the side frame and
through the
1/2”
hole in the floorboard. See Figure
15.5. The harness will be secured at a later step along
with the heater hoses.
The rest of the connections will be finished after the
heater installation.
Fig. 15.1 (Attach Main Harness To Wiper Connector)
Fig. 15.3 (Route Harness To Heater Switch)
Secure With
P
-
Clip
Fig. 15.5 (Harness Runs Down Side Frame)
Fig. 15.2 (Secure Harness With P
-
Clips)
Secure With
P
-
Clips
Secure With
P
-
Clip
Heater
Switch
Cable Tie
