Curtis Dyna-Fog 2742, Manual

Page: 27 / 84

FLUSHING SYSTEM
The system must be flushed after each use to protect the equipment from the
corrosive material in the formulation.
CAUTION
Never handle any parts on the that come in contact with formulation until the
unit has been thoroughly flushed with isopropyl alcohol or other
recommended flushing agent.
TO FLUSH SYSTEM:
1. If the unit is equipped with the Curtis Syncroflow system, verify that the
“Manual-Syncroflow” switch located on the pump control box is in the
“Manual” position.
2. With the engine and blower operating, place the "MODE" momentary toggle
switch on the remote control box in to the "Flush" position (hold it in to the flush
position).
3
. Verify that the "Function Select" dial on the remote control box is in the position
number 2 (or 4).
4. Turn clockwise the "Rate" knob on remote control knob to maximum flow.
5. Place "OUTPUT" toggle switch on remote control box into the "ON" position.
6. Flush for 3 to 5 minutes.
7. Place "OUTPUT" toggle switch on remote control box into the "OFF" position.
8. Release the "MODE" momentary toggle switch from the "Flush" position.
FLUSH OPERATION. SEQUENCE WITH REMOTE CONTROL BOX
(1) HOLD THE
SPRAY/FLUSH
TOGGLE SWITCH
IN THE FLUSH
POSITION
(3) MOVE THE
“OUTPUT”
SWITCH TO “ON”
(2) TURN “RATE” KNOB
CLOCKWISE TO
MAXIMUM FLOW
(4) AFTER ABOUT 3
MINUTES, MOVE THE
“OUTPUT” SWITCH TO
“OFF”, THEN RELEASE
FLUSH SWITCH
27