Curtis Dyna-Fog 2742, Manual

Page: 12 / 84

MACHINE INSTALLATION
1 . Remove the machine from the skid and lift the machine onto the vehicle with the
discharge end of the machine toward the rear of the vehicle.
2. Pass the remote control unit through an open window and locate it within reach of
the person operating the machine. If permanent vehicle installation is desired, the
remote control cable can be fed through a clearance hole in the vehicle chassis
and then reconnected. When drilling clearance holes, ensure that all sharp edges
are removed and covered to prevent premature wearing of the remote cable. When
routing the cable to the vehicle cab, do not allow the cable to be exposed to any
sharp edges. Avoid sharp bends when routing the cable. Once the cable has been
routed to the cab, reseal all drilled openings to prevent moisture and/or exhaust
gases from entering the cab.
3. Using the (3) hold-down brackets used for mounting the machine to the shipping
skid, securely mount the machine to the bed of the vehicle (see diagram below).
Depending on the type of bed surface, it may be necessary to use additional
mounting hardware to secure the machine.
WARNING
NEVER ATTEMPT TO OPERATE THE MACHINE WITHOUT FIRST VER I FY I NG THAT IT IS
SECURELY MOUNTED. FAILURE TO DO SO COULD RESULT I N SEVERE INJURY.
12