Curtis Dyna-Fog 2742, Manual

Page: 16 / 84

PRE-SPRAY CHECK LIST
1. Verify that the remote control box is within easy reach of the operator.
2.
Verify that the adjustable nozzle boom is in the correct position as required for
the spraying operation to be accomplished, and that the ring damp which allows
this positioning is tight.
3. Verify that the engine has sufficient fuel and is properly lubricated.
4. Verify that the blower has been serviced.
5. Inspect all hoses for abnormal conditions.
6. Verify that no foreign objects or tools have been left in or about the machine.
7. Verify that the sufficient amount of formulation is in the tank and that the tank
filling cap is tight and it’s air vent hole is not restricted.
8. Verify that the battery is mounted security and cable connections are proper
and tight.
9. Verify that all safety equipment is in place and is in proper working order.
10. Verify that the flow rate control has been calibrated and is dispensing
formulation in accordance with the manufacturers label requirements.
CAUTION
BEFORE PROCEEDING WITH ANY SPRAYING OPERATION, THE OPERATOR
SHOULD BE THOROUGHLY FAMILIAR WITH STARTING AND STOPPING THE
MACHINE AND WITH ALL THE OPERATING^ CONTROLS. IF YOU ARE OPERATING
THE MACHINE FOR THE FIRST TIME, EXERCISE THE MACHINE THROUGH ITS FULL
OPERATIONAL SEQUENCES FROM A POSITION OF FULL VISIBILITY OF THE
MACHINE BEFORE OPERATING THE MACHINE FULLY REMOTE. THIS IS ALSO A
GOOD IDEA FOR EXPERIENCED OPERA TORS WHO MAY BE OPERATING A NEW
MACHINE OR WHO MAY BE REACTIVATING A MACHINE AFTER REPAIRS OR A
PERIOD OF INACTIVITY. REFER TO THE ENGINE MANUAL FOR STARTING AND
STOPPING INSTRUCTIONS.
16