4
60
CUES Inc.
,
MPlus+ User Manual | CH905
www.cuesinc.com
,
OPERATING THE SYSTEM
When the ARROW MODE button is pressed, a blinking arrow is displayed in the middle of the
display, pointing right. This blinking arrow may be moved around using the arrow keys. When
an arrow key is pressed, it will either change the direction of the blinking arrow displayed on
the screen, or move the blinking arrow on the screen one position vertically or horizontally. If
the arrow key pressed is different from the current direction of the blinking arrow displayed, it
will change the blinking arrow’s direction. If the arrow key pressed is the same as the current
direction of the blinking arrow displayed it will move the blinking arrow on the screen one
position in that direction.
The blinking arrow on the screen should be positioned to point at the observation desired. Once
it is properly positioned, pressing <ENTER> will cause the blinking arrow to stop blinking and
be moved from the ONSCREEN to the CAMERA display, where it will be recorded (assuming
the DVR is on).
• OBSERVATION CODES - press to select and enter observation codes
while recording the inspection.
Selecting a CUES CODE or CUSTOM CODE observation code:
When the operator has made CUES CODES or CUSTOM CODES his observation code type
and then presses the OBSERVATION CODES button, a list of codes is displayed alphabetically
with an arrow pointing at the middle line of the display. The operator may move up and down
through the list using the Up Arrow or Down Arrow keys. However, he may more easily move
about the list by pressing the first character of the desired code and the list will jump to that
section of the list (or the nearest letter prior to that letter).
In the CUES CODES list items that are followed by ‘…’ have a secondary list from which to
select.
Moving around the lists is all displayed in the ONSCREEN display, which will not be recorded.
In both the CUES CODES and CUSTOM CODES pressing <ENTER> will select the code (or
take one to the secondary list, at which time pressing <ENTER> again will select the code).
When a code is selected, it is written to the top one or two lines of the CAMERA display which
will be recorded (assuming the DVR is on).
