CTC Union FRM220-100AS-1, User Manual

Page: 34 / 83

34
CHAPTER 3
PROVISIONING VIA TEXT MENU
<8> Tag's CoS Mapping to Internal Classify : The Class of Service is a 3 bit field within an Ethernet
frame header when using 802.1Q tagging. The field specifies a priority value of between 0 and 7
inclusive that can be used by Quality of Service (QoS) disciplines to differentiate traffic. The
internal Ethernet switch of
100AS-1 supports only 2 bit priority values, 0 to 3 inclusive. This
function is used to map CoS 8 levels to the internal switch’s 4 QoS priority levels.
<A>
Remote H/W Reset : This function will request the remote unit (fiber port connected unit) to
do a warm boot startup. This remote unit must have enabled the "Accept Remote H/W Reset"
function, or it cannot be remotely reset.
<L>
Load Default Settings and Write to System : This function will load all the factory default
settings and write them to the internal non-volatile ram. This is "almost" equivalent to doing the
"Default" factory reset with the front panel 'Default' push-button switch. Using this function will
NOT default the TCP/IP settings (IP address, mask, gateway, etc.).
<R>
System Reboot : The unit will undergo a 'warm boot' if this function is selected and confirmed.
3.6 Advanced Functions
100AS-1 has several sets of pre-defined 'advanced functions' which allow the user to quickly
configure the switch for specific applications. Each of these is shown below and will be explained
in detail.
<0>
Normal : This is the default mode of 100AS-1 . In this mode the unit is a simple managed
Ethernet media converter/switch.
<1>
Static 802.1Q VLAN : This mode will open up the unit to further configuration for 802.1Q VLAN
settings. This mode's application drawing and details are shown in 3.6.1 Static 802.1Q VLAN.
*********************************************
*** CTC UNION TECHNOLOGIES CO., LTD. ***
*** FRM220-100AS-1 Ver:1.005 ***
*********************************************
<< Local Device Status and Configuration >>
<1> :MAC Learning Function [Enable ]
<2> :Pause Frame [Disable]
<3> :Advance Functions [Normal ]
________________________________________________________________
Select Advance Functions.
<0> Normal
<1> Static 802.1Q VLAN
<2> Q-in-Q VLAN
<3> 802.1Q VLAN Trunk
<4> Spanning Tree Protocol
<5> Spanning Tree Protocol & Static 802.1Q VLAN
<ESC>:Previous Menu.