CTC Union FRM220-100AS-1, User Manual

Page: 13 / 83

13
CHAPTER 3
PROVISIONING VIA TEXT MENU
*********************************************
*** CTC UNION TECHNOLOGIES CO., LTD. ***
*** FRM220-100AS-1 Ver:1.005 ***
*********************************************
Fiber [Link Down ] [Remote LB: Off ]
UTP [Link Down ] [Speed: -----] [Duplex: ----]
Remote Module [Empty ]
Port 1 OAM Mode [Active ]
Advance Functions [Normal ]
<L> :Local Status and Configuration.
<A> :Remote Status and Configuration.
<M> :SNMP Manager.
<S> :System Configuration.
<ESC>:Logout.
CHAPTER 3. PROVISIONING VIA TEXT MENU
3.1 Introduction
100AS-1 has an easy to use menu system that is accessible both through a local serial console
(terminal) connection and through a Telnet connection via TCP/IP network over Ethernet. Both the
serial console and Telnet protocol management methods are employed to provide an easy to use,
text based, menu system for performing all configuration functions. In most cases, we recommend
that the networking engineer start configuration by using serial terminal. Configure the required
TCP/IP parameters for the network deployment, and then continue detailed configurations using
the Web Based GUI. For GUI operation, please refer to Chapter 4.
3.2 Serial Console Login
Serial console login is available when 100AS-1 is placed in a single slot chassis with DB9 serial
connection such as the CH01M. Connect a 1:1 RS-232 serial cable between the DB9 female on the
1-slot chassis to any available COM port on a PC. Use a terminal emulation program such as
HyperTerminal, PuTTY, or TeraTerm Pro. The latter two are freely available by searching the
Internet. Configure the terminal for 115.2k, 8bit, no parity, 1 stop bit, no flow control and VT-100
emulation.
3.2.1 Main
From the factory, no username or password is required to access the console management of
100AS-1 . If the password is set and forgotten, please do a factory default (refer to 1.7 Factory
Reset Procedure.) When factory reset, the username and password will both be ‘admin’, if
password checking is enabled.
The console operation of
100AS-1 uses a simple menu system. From the main menu, using ESC will
prompt for a logout. The menu items are selected by simply keying in the menu item's number (in
the < > brackets). Some parameter settings are toggled by a single key stroke, while others are
selected from additional sub-menus. Unless advised that the unit requires a reboot, all settings
take effect immediately
The following is an example of the Main Menu.