CTC Union FRM220-100AS-1, User Manual

Page: 33 / 83

33
CHAPTER 3
PROVISIONING VIA TEXT MENU
The setting options are explained below.
<1>
MAC Learning Function : Ethernet frames are processed by the MAC learning function and
used to populate the MAC filtering address table. The table, which holds up to 1000 addresses, is
then used to correctly forward outgoing frames to the right port. When the learning function is
disabled, a packet arriving at one port will then be forwarded transparently to the other port. No
filtering will be done, because the MAC filtering table will be empty.
<2>
Pause Frame : PAUSE is a flow control mechanism on full duplex Ethernet link segments
defined by IEEE 802.3x and uses MAC Control frames to carry the PAUSE commands. Pressing the
"1" key here will toggle this function between enabled or disabled.
<3>
Advanced Functions : 100AS-1 acts as a normal L2 switch when the setting here is 'normal'.
Advanced functions are explained in detail in 3.6 Advanced Functions.
<4>
Upnp : UPnP or Universal Plug 'n Play is a set of networking protocols promulgated by the
UPnP Forum. When connected to a network, 100AS-1 will automatically announce its network
address and supported device and services types, enabling clients that recognize those types to
immediately begin using the device.
<5>
QoS Priority Mode : The priority mode may either be set as 'Weighted' or as 'Strict'. Note:
'Strict' mode could result in packet starvation.
<6>
Maximum OAMPDU Size : This sets the maximum size of the OAM Protocol Data Unit (PDU).
In order for two devices to communicate properly at the OAM level, this setting must be the same.
We recommend leaving the default setting size of 1500.
<7>
Accept Remote H/W Reset : When this parameter is enabled, the remotely connected unit will
be allowed to reset this device if it gives the proper OAM command. If this parameter is disabled
(default), the remote unit's reset command will be ignored by this unit.
<< Local Device Status and Configuration >>
<1> :MAC Learning Function [Enable ]
<2> :Pause Frame [Disable]
<3> :Advance Functions [Normal ]
<4> :UPnP [Disable]
<5> :QoS Priority Mode [Weighted]
<6> :Maximum OAMPDUs Size (60 ~ 1518 Octets) [1500]
<7> :Accept Remote H/W Reset [Disable]
<8> :Tag's CoS Mapping to Internal Classify.
<A> :Remote H/W Reset.
<L> :Load Default Settings and Write to System.
<R> :System Reboot.
<ESC>:Go to Previous Menu.