17
6. CONTROL PANEL OPERATION
BEFORE ENTERING BACKWASH MODE YOU MUST BE IN THE DDS SCREEN.
ALWAYS FOLLOW MANUFACTURERS INSTRUCTIONS.
[FILTER CLEAN] can also be entered by pressing the [OK] button in the MAIN MENU and scrolling to
BACKWASH MODE.
IF UNSURE PERFORM MANUALLY BY PRESSING [POWER] ON&OFF TO
DO THE FILTER CLEAN.
During BACKWASH the [POWER] button displays the ON LED when the pump is
running and the OFF LED displays when the pump is stopped.
Pressing [OK] starts the pump for
2
minute
s
and TIME LEFT will be displayed
Pressing [<] or [FILTER CLEAN] allows you to exit and this takes you to
BACKWASH COMPLETE.
Pressing the [OK] button starts the pump for
2
minute
s
.
automatically counting down in 1 sec increments.
Pressing [OK] stops the pump and RINSE MODE is displayed.
TIME LEFT automatically starts counting down in 1 sec increments.
RINSE MODE will then be displayed.
otate the filter multi port al e to the a
a h po ition, en ure the
handle locks in place and once ready press [OK] to enter the RINSE MODE
cycle.
Once dirty water in the waste pipe or sight glass is clear then press [OK] to
fini h
and enter
n e dirty ater in the a te pipe or ight gla i lear pre
to fini h
pla e and on e ready pre
to enter the final
cycle.
Pressing [OK] stops the pump and BACKWASH COMPLETED
is displa yed.
otate the filter multi port al e to the filter po ition, en ure the handle
locks in
6.7 BACKWASH
NEVER OPERATE THE FILTER LEVER WHILE THE PUMP IS RUNNING YOU MAY
DAMAGE THE SEAL AND LEAKS MAY OCCUR.
THE PUMP WILL START AND STOP AS YOU REQUIRE.
,
,
,
,
IMPORTANT INFORMATION BEFORE PERFORMING A BACKWASH.
[
utton a i t you in the operation o your pump and filter during the a
a h pro e
www.crystalas.com
65a010a5-6d71e2d3-6b3148b4-770d42ea
65a010a5-6d71e2d3-6b3148b4-770d42ea
