26
10. SYSTEM TROUBLESHOOTING
WATER TEMP SUDDEN
o ater o
Possible closed valve, pump
10.9
Not operating at all - no
Not plugged into power
Check that POWER PACK POWER
CORD goes into wall outlet and
outlet is turned on
10.1
Everything displays OK but
Incorrect TIMER settings
Press POWER/MODE button
10.1
Check TIMER settings (sec.
Build up of calcium on the
Calcium acts as an insulator
and needs to be removed
See Cleaning of Cell
Winter water temperature
can be very low
For every 1°C below 28°C the
n u fi ient ater o
through the
Cell
Housing
Plugged into power point
Test wall outlet with a
No, it does not work.
If the FAULT LED is ON then refer
to 9.1 above. If only LCD DISPLAY
is ON but nothing works - call for
service
Sign of melting or burning of the
Cell Connector Plug
Possible moisture entry to the
plug
If melted then it will need
replacing otherwise clean with
WD40 or similar. Return for service
if melted
10.1
3
OUT
PUT
reading
is
less than
Low salt level
Check salt level (sec. 6.6/8.2)
10.1
Wall outlet working but still
no power
Check CIRCUIT BREAKER at
bottom of POWER PACK
Press white button to reset if
tripped
Pressed and reset but still no
power
If you have checked all of the
above then there is an internal
fault - contact for service
CIRCUIT BREAKER stays out
Faulty CIRCUIT BREAKER - contact
for service
Not operating at all - comes
on but turns off
CIRCUIT BREAKER resets but
trips again
2. Short across Cell plates -
remove Cell and check the plates
for any metal lying across plates
3. Faulty rec
, transformer or
Cell cable - call for service
1. Excessively high salt - check salt
(sec. 6.6/8.2) and lower it if
needed
10.1
1
You may need to backwash your
. 6.7)
w and ensure a full
chamber of water is passing over
the Cell
www.crystalas.com
65a010a5-6d71e2d3-6b3148b4-770d42ea
65a010a5-6d71e2d3-6b3148b4-770d42ea
