25
10. SYSTEM TROUBLESHOOTING
If you suspect for any reason your
VAPURE VP-Series Salt Chlorinator
is not performing or running as it
should be, here are some handy troubleshooting tips that may assist you.
FAULT LED «ON»
Numerous causes
See the LCD DISPLAY for the
reason then go to that section in
this troubleshooting guide
10.1
HIGH SALT WARNING
Salt too high or short on cell
plates
Check Salt guide (sec. 6.6/8.2)
Check that cell is clear of any
foreign materials (e.g. wire, metal,
touching plates, etc)
10.2
INTERNAL TEMPERATURE
HIGH
w in the area around the
POWER PACK or excessively high
salt
Check Salt guide (sec. 6.6/8.2)
Ensure POWER PACK is mounted
in a well ventilated area free of
chemicals and fertilisers
10.3
LOW SALT or CLEAN CELL or
FAULTY CELL
Low salt level
Check salt level (sec. 6.6/8.2)
10.4
NO CURRENT FLOW - NO
Faulty CONTROL or MAIN
Faulty PCB -
contact
for
10.5
Build up of calcium on the
Cell plates
Calcium acts as an insulator
and needs to be removed
See Cleaning of Cell
Water does not cover the
Low speed pump not
Increase the speed of the
pump until hou ing i filled
o ater o
Possible closed valve, pump
fault, burst pipe
Water temperature is low
Winter water temperature
can be very low. For every
n u fi ient ater o
through the Cell
w and ensure a full
chamber of water is passing over
the Cell.You may need to
backwash y
. 6.7)
The Cell could be damaged
or at the end of its life
Damaged coating will reduce cell
life and reduce output
If all conditions are correct then
Cell could be at the end of its life
Level low in one direction
but OK in the other
Cell may need cleaning (sec.
9.1) or the Cell may have run
WATER TEMP HIGH
o ater o
Possible closed valve, pump
10.7
WATER TEMP LOW
Water temperature is below
1
0
°C
The POWER PACK will lower
output when water temperature
goes below 10°C to protect the
cell plates
10.8
www.crystalas.com
65a010a5-6d71e2d3-6b3148b4-770d42ea
65a010a5-6d71e2d3-6b3148b4-770d42ea
