24
9.
CHLORINATOR
MAINTENANCE
HANDY TIP:
Returning this mix to your pool only returns the calcium you just removed, so you may be better
off reusing the solution until exhausted then disposing of it. Always store this solution in a safe
method as advised on the container.
Do not scratch or bend the electrode plates in the Cell Housing.
Ensure that the O-ring is clean, greased and properly seated.
Rinse the electrode in clean water and re
trode in the Cell Housing, ensuring that the Cell Locking Ring is
hand tight and secure.
9.2 Inspecting the Power Pack
Little or no maintenance is normally required with the
VAPURE VP-Series Salt Chlorinator
Power Pack.
Ensure the Power Pack 3 pin plug plugs into a suitable weatherproof RCD protected 10amp outlet. Ensure that the
pump plugs into the 3 pin AC Socket located at the bottom of the Power Pack. Check all plugs and cords for
damage. If damaged then it should be replaced by the manufacturer
order to avoid a hazard.
If the chlorinator is to be hard wired
trician must complete the installation.
The
VAPURE VP-Series Salt Chlorinator
Power Pack has air vents to allow internal components to remain cool in
hot weather. The
VAPURE VP-Series Salt Chlorinator
has a special oil spray applied to the inside of the unit during
production to stop the insects from entering the unit. To help assist in keeping the insects away, apply a surface
spray periodically on the wall or post that the unit is mounted on. DO NOT spray directly into the Power Pack and
make sure the pow
ou spray. Allow adequate time for the spray to dry before turning power on
again.
When mixing acid with water, ALWAYS ADD ACID TO WATER. NEVER ADD WATER TO ACID.
Eye Protection, mask and gloves should be worn when cleaning the cell.
www.crystalas.com
65a010a5-6d71e2d3-6b3148b4-770d42ea
65a010a5-6d71e2d3-6b3148b4-770d42ea
