Connect the Cell Housing horizontally in the return line to the pool (use reducing bushes supplied if
40mm PVC pipe) using high pressure PVC glue. The Cell Housing can be mounted vertically but
provision must be made for a gas trap.
Direction of wate ow through the Cell Housing is not critical although we do recommend entry from
the closed end of the Cell Housing and exit from the end closest to the Cell Locking Ring. The reason is
to cause less water hammer over time on the cell plates.
Check that the O-ring is clean, greased with silicone grease (DO NOT use petroleum based jelly) and
securely located in the Cell Housing.
Ensure Cell Locking Ring i rmly tightened by hand (DO NOT use a tool to tighten).
Connect the lead from the Cell Electrode to the Cell Plug under the Power Pack ensurin
rm snap
lock connection.
Plug the Power Pack 3 pin plug into a suitable weatherproof RCD protected 10amp outlet and then
plug the pump into the 3 pin AC Socket located at the bottom of the Power Pack.
The VAPURE VP-Series Salt Chlorinator has a Ingress Protection Rating of IP23 enabling it to be installed
outdoors. Regulations require that the Power Pack shall be installed outside the pool zone. The Power
Pack shall be installed according to AS/NZS 3000 wiring rules.
The Power Pack should be installed in a well ventilated position ideally away from sunlight and rain to
prolong life and at least 1m above ground to prevent run o
ater entry.
Ensure that the Power Pack is not stored near chemicals, fertilisers or in a closed unventilated shed with
similar products as the fumes will cause excessive corrosion and damage to the internals of the Power
Pack and may void warranty.
When mounting the Power Pack on a post it is recommended to instal
at panel at least the same
size to act as a waterproof backing plate.
Mount the Power Pack with the Mounting Bracket, Green Plugs and Screws provided.
The Power Pack should be mounted no further than 1.5 metres from the Chlorinator Cell for ease of
operation.
8
4
. POWER
PACK
AND
CELL
INSTALLATION
4.2
Cell Electrode Installation
4.1
Power Pack Installation
www.crystalas.com
65a010a5-6d71e2d3-6b3148b4-770d42ea
65a010a5-6d71e2d3-6b3148b4-770d42ea
