16 issue 5
17. Commissioning the appliance
Remove the customers chosen fuel effect pieces from the pack and check that none are broken or damaged.
If Logs or Driftwood has been chosen it will be necessary to leave the
Log Support
fitted with the 3
Screws see
Fig 17:1
.if pebbles have been chosen it will need removing
Making reference to the photographs in
Sections 18 for Logs or Driftwood and Section 19 for Pebbles in
the Installation Instructions
fit the Fuel
Fig 17:1
Important
Ensure the Burner Ceramic Base Pad is fitted the Right way
around with the central slot at the rear
Normally factory fitted
Ensure no granules are placed on top of the Burner Ceramic
Base Pad.
Only place Bark Chips in the areas shown.
Ensure the Pilot is visible and not covered especially when
fitting Pebbles onto the Ceramic Base Pad.
Seal closed the
Glass Door
after checking that the glass is clean
using the screws to secure it
Fit the
Outer Door
using the
Hinge Pins
provided. See
Fig 17:2.
Fig 17:2
With making reference to 2:1 light the pilot turn on the appliance and check the gas pressure of the
appliance is 20 mbar on full
