Software Crestron
Serial Mouse Control Driver
1. Using the Crestron Viewport, (
Remote | TCP/IP | Connect
or
Remote | Remote
Console | Connect
) establish communication with the touchpanel.
2. As shown on the next page, use the
ipt
(IPTABLE) command to display the
current IP table for the CIP interface on the touchpanel.
IP Table
3. As shown below, using the
addm
(ADDMASTER) command to add a CIP node
to the master list of the touchpanel, enter the information in the following format
with spaces (no period or underscore) between the entries: CIP ID from SIMPL
Windows (example of
4
is shown), IP address of touchpanel (example of
132.149.010.147
is shown), and Device ID (example of
4
is shown).
NOTE:
The Device ID of the Serial Mouse Control Driver
MUST
match the CIP ID and
will also be used in step 6 of “
VT Pro-e Programming
” that begins on page
16
.
Add Device ID to Table
12
•
Serial Mouse Control Driver
Programmer’s Guide - DOC. 5916A
