Crestron
IM-RX1 & IM-RX3
iMedia Receiver/Processor
IR
This red LED indicates IR port output activity when sending out control
commands.
COM
This red LED indicates COM port activity when sending or receiving
commands.
Industry Compliance
As of the date of manufacture, the IM-RX1 and IM-RX3 have been tested and
found to comply with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling.
NOTE:
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Setup
Network Wiring
CAUTION:
In order to ensure optimum performance over the full range of
your installation topology, Crestron Certified Wire, and only Crestron Certified
Wire, should be used. Failure to do so, may incur additional charges if support is
required to identify performance deficiencies as a result of using improper wire.
CAUTION:
Use only Crestron power supplies for Crestron equipment. Failure
to do so could cause equipment damage or void the Crestron warranty.
Mounting
The IM-RX1 and IM-RX3 can be mounted using the included four mounting
brackets. Attach the included brackets using the existing cover screws located on
the sides of the IM-RX1/IM-RX3 as shown in the following diagram.
Operations & Installation Guide – DOC. 6384
iMedia Receiver/Processor: IM-RX1 & IM-RX3
•
11
