Crestron
IM-RX1 & IM-RX3
iMedia Receiver/Processor
COMPUTER
This 6-position RJ-11 mates with a serial port of a PC; connecting cable is not
supplied. Use this port for direct connection to the PC to load files. In the event
that modular cables or an RJ-11 to DB9F adapter is not available, the diagram
and table that follows provide information so that the cable can be fabricated on
site. Can be used as the console port.
PC to IM-RX1/IM-RX3 Cable Specifications
NOTE:
If you do not have this cable, you can use a crossover Ethernet cable to
communicate with this device.
RS-232 Pinouts
PIN
DESCRIPTION
1 CTS
2
GND
3 RXD
4
TXD
5 RTS
6
N/C (Not connected)
1
6
1
6
Front
Top
NOTE:
This cable is the Crestron STCP-502, and is included in the ST-PK
programming cable kit.
LAN
LAN
8
1
Yellow
Green
An 8-position RJ-45 port (labeled
LAN
) is used for connection to the Ethernet,
providing local area network or Web access (cable is not supplied). Supports
10/100BaseT. The port also contains two light-emitting diodes (LEDs). The
green LED on the left side of the port is a link status LED and illuminates when
the card is connected to a working network. The yellow LED on the right side
flashes to indicate Ethernet activity. Refer to “Set IP Information” on page 25
for the default IP address.
Operations & Installation Guide – DOC. 6384
iMedia Receiver/Processor: IM-RX1 & IM-RX3
•
9
