Configuring the Wireless LAN USB Adapter 4-3
Configuration
Settings
1. Click the
Configuration
tab (see
Figure 4-3). In this tab, you can change the
default configuration settings below.
2. To create a new profile, click the
Profile
box, and then type a name in the box.
3. Click the
Create
button.
4. To switch between profiles, click the
Profile
box, and then click the profile that you
want.
5. Click the
Activate
button.
6. To remove a profile, click the
Profile
box,
and then click the profile that you want.
7. Click the
Remove
button.
8. Click the
Operating Mode
box.
If you are connecting to a network through
an access point, click
Infrastructure
.
If you are connecting to a network without
an access point, click
Ad-hoc
.
9. Click the
Service Set Identifier
(SSID)
box.
In Infrastructure mode, set the SSID to the SSID of the access point.
In Ad-hoc mode, set the SSID to the SSID of the Ad-hoc station you want to
connect.
10.Click the
Transfer Rate
box, and then click the transfer rate that you want.
11.Click the
Channel
box.
In Infrastructure mode, you need not set the channel. The channel for the access
point is already set for you.
In Ad-hoc mode, set the channel to the channel of the Ad-hoc station you want
to connect.
Figure 4-3:
Configuration
tab
A profile is a set of
pre-defined values.
Service Set Identifier
(SSID)
is case sensitive.
Summary of Contents for Blaster 2030
