© Copyright 2014, Creative Playthings
MODEL PSRAL
19864-300 Rev A (07-20)
Page 14
ASSEMBLY INSTRUCTIONS
AM
V
AE
W
STEP 14 — Access Ladder Rungs & Slat:
Fit four 15" Rungs (AM) into the holes in the Left Ladder
Rail (V) and the Right Ladder Rail (W). Set the assembly flat
on a solid surface. Make sure that the rungs are completely
inserted with the ends of the rungs snug against the bottom
of the holes.
Use #10 x 1-1/2" Self-Drilling Screws, through the holes
provided, to fasten the rungs in place. (The Self-Drilling
Screws have a drill-bit tip. Point the screw toward the center
of the rung diameter and press firmly. Do not sink the head of
the screw beyond flush with the surface of the wood.
Use four #10 x 1-5/8" Screws to fasten the Ladder Slat (AE)
to the Ladder Rails. The top edge of the Ladder Slat should
be about 2-1/4" below the top of the Ladder Rails as shown.
STEP 15 — Mount Access Ladder:
Fasten one Access Bracket to outside of each Ladder Rail
using 1/4 x 1-1/2" Hex Bolt Assemblies.
Lean the Access Ladder against the gym with the Access
Brackets flat against the Platform Back as shown. Secure
the Brackets using 1/4 x 1" Hex Bolt Assemblies.
The top of
the ladder
1/4 x 1" Hex Bolt
1/4 x 1-1/2" Hex Bolt
2-1/4"
STEP 13 — Left Lower Wall Support:
Fasten the Lower Wall Support (AG) to the outside of the
left Posts in the position shown, using two 1/4 x 2" Hex Bolt
Assemblies in the top holes and two 1/4 x 2" Lag Screws in
the bottom holes.
2" Lag
Screws in
Bottom Holes
2" Hex Bolt
Assemblies in
top holes
AG
