© Copyright 2014, Creative Playthings
MODEL PSRAL
19864-300 Rev A (07-20)
Page 10
ASSEMBLY INSTRUCTIONS
Back of
tower
Back of
tower
Front of
tower
Front of
tower
STEP 3 — Left Sandbox Side:
Arrange the back tower assembly and front tower assembly next to each other on edge as shown below.
Fasten one Sandbox Side (E) to the Front Left (J) and Back Left (H) Posts as shown at below. Use 1/4 x 2" Hex Bolt Assemblies
in the top holes and 1/4" x 2" Lag Screws with 1/4" Flat Washers in the bottom holes.
H
J
E
G
P
1/4 x 2" Hex Bolts in
top holes, 1/4 x 2" Lag
Screws in bottom holes.
1/4 x 2" Hex Bolts in
top holes, 1/4 x 2" Lag
Screws in bottom holes.
1/4 x 2-1/2" Hex
Bolts Assemblies
STEP 4 — Platform Side Left, One Wall Support:
Fasten the Platform Side Left (G) to the Back Left Post
and Front Left Post in the orientation shown using
1/4 x 2-1/2" Hex Bolt Assemblies. Note the
hole positions along the board.
Fasten one Upper Wall Sup-
port (P) to the Front Left (J)
and Back Left (H) Posts as
shown at right. Use 1/4 x 2"
Hex Bolt Assemblies in the top
holes and 1/4" x 2" Lag Screws
with 1/4" Flat Washers in the
bottom holes.
