© Copyright 2014, Creative Playthings
MODEL PSRAL
19864-300 Rev A (07-20)
Page 20
ASSEMBLY INSTRUCTIONS
STEP 29 — Swing Beam & Swings:
Install the Swing Beam as instructed by the assembly guide
included with the Beam.
Hang the Swings and Ring Trapeze in the positions shown
at right.
U.S. safety standards require a minimum clearance of 8"
from the bottom of each Swing Accessory to the ground.
U.K. (& E.U.) safety standards require a minimum clearance
of 350mm (13-3/4") between the bottom of each Swing Ac-
cessory and the ground.
The height of each Swing Accessory is adjusted by using a
different link in the chain. Be sure to hang the Swings Ac-
cessories with ground clearance greater than or equal to the
safety standard for your region.
STEP 30 — Ground Stakes:
Hammer two Ground Stakes (L) next to the Front Left Post
and Back Right Post as shown. The top of the Ground Stake
should be minimum of 1/8" below the top of the Sandbox
Sides. Secure each stake to the adjacent Post using two #10
x 2-1/2" Screws through the pre-drilled holes.
Hammer Ground Stakes next to the Access Ladder and Rock
Upright. Secure each stake with two #10 x 2-1/2" Screws
through the pre-drilled holes. Secure the Beam Legs in the
same manner.
Note: Do NOT use concrete to set Ground Stakes. Pound a
metal spike or rod into the ground to start a hole in hard or
rocky ground.
Inspect your work; make sure all fasteners are secured prop-
erly and the area is clear of hazards before allowing children
on the Swing Set.
Save all instruction sheets and receipts in case it becomes necessary to contact
Creative Playthings for warranty service and/or part replacement. The warranty
can be found in your Owner’s Manual.
