MODEL PSRAL
19864-300 Rev A (07-20)
© Copyright 2014, Creative Playthings
Page 9
ASSEMBLY INSTRUCTIONS
J
K
B
L
D
The parts required to start assembly are in box 1;
subsequent parts are in box 2.
Hex Bolt Assembly:
Throughout this guide a Hex Bolt As-
sembly consists of one Hex Bolt, one
Lock Washer, one Flat Washer and
one Weld Nut.
STEP 1 — Front of Tower:
Fasten one Sandbox End (D) to the front of the Front Left
Post (J) and Front Right Post (K) as shown. Use 1/4 x 4"
Hex Bolt Assemblies in the top holes and 1/4" x 2" Lag
Screws with 1/4" Flat Washers in the bottom holes.
Repeat the process with the Platform Front (L) and Front
Arch (B). Align the central hole on the Platform Front clos-
er to the Front Right Post (K).
STEP 2 — Back of Tower:
Lay out the Right Back Post (I) and Left Back Post (H) next to the Front of Tower
Fasten one Sandbox End (D) to the front of the Back Left Post (H) and Front Right Post (I) as shown. Use 1/4 x 4" Hex Bolt
Assemblies in the top holes and 1/4" x 2" Lag Screws with 1/4" Flat Washers in the bottom holes.
Repeat the process with the Platform Back (M) and End
Support (N). Align the central hole on the Platform Back
closer to the Back Right Post (I). The holes close to the
edge should be closest to the bottom of the tower.
I
J
H
K
N
M
D
1/4 x 4" Hex Bolts in
top holes, 1/4 x 2" Lag
Screws in bottom holes.
Note the orientation
of these holes.
Note the orientation
of these holes.
1/4 x 4" Hex Bolts in
top holes, 1/4 x 2" Lag
Screws in bottom holes.
