© Copyright 2014, Creative Playthings
MODEL PSRAL
19864-300 Rev A (07-20)
Page 18
ASSEMBLY INSTRUCTIONS
STEP 24 — Climbing Rope:
Push one end of the Climbing Rope (AN) through the hole in
the Top Rope Support. Tie a figure-eight knot at the end of
the rope, inside the gym. Leave at least 3" of rope extending
beyond the knot inside the gym.
From the outside of the gym, tie an overhand knot approxi-
mately every 9" along the length of the rope. Make sure each
knot is tight.
Push the loose end of the rope through the hole in the Rope
Board. Pull the rope taut and tie a figure-eight knot to secure
it.
Set the Rock Uprights into the playground surface to
ensure that the bottom rope connection is as close to
the ground as possible.
IMPORTANT: Check the rope often. At no time should
the bottom end of the rope be untied or the rope loose
enough to form a loop. This presents extreme danger to
children.
AF
AN
Figure Eight
Knot
If the rope is too
long, tie extra
knots along the
length of the
rope. If too short,
remove knots.
Overhand
Knot
STEP 25 — Safety Rail:
Fasten the Safety Rail (AF) to the left posts using one 1/4
x 2" Lag Screw and Flat Washer in each end. Use the pre-
piloted holes provided.
1/4 x 2" Lag Screws
STEP 23 — Wall Slats:
Fasten three Wall Slats (AC) in place as shown.
Use #8 x 1-1/4" Screws for the upper holes.
Use #10 x 1-5/8" Screws in the lower holes.
Evenly space the Slats between the Narrow Deck Board and
Back Right Post.
The gap between the Slats will be approximately 1-1/2". Use a
level to ensure the Slats are Plumb.
AC
#10 x 1-5/8" Screws
in the bottom holes.
#8 x 1-1/4" Screws
in the top holes.
