MODEL PSRAL
19864-300 Rev A (07-20)
© Copyright 2014, Creative Playthings
Page 19
ASSEMBLY INSTRUCTIONS
AO
AO
STEP 27 — Rock Hand Grip:
Hold one Hand Grip (AO) against the right face of the front
right Post next to the Rock Climber. The lower hole should
be 8" above the top of the platform.
Fasten with 1/4 x 1-1/2" Lag Screws and Flat Washers, us-
ing the pre-drilled holes provided.
STEP 26 — Back Hand Grips:
Hold one Hand Grip (AO) against the back face of the back
right Post above the Access Ladder. The lower hole should
be about 8" above the top of the platform.
Fasten with 1/4 x 1-1/2" Lag Screws and Flat Washers, us-
ing the pre-drilled holes provided.
Repeat with another Hand Grip against the back of the back
left Post.
1/4" x 1-1/2" Lag
Screws
8"
8"
1/4" x 1-1/2"
Lag Screws
STEP 28 — Slide:
Center the Slide (AP) in the opening in the tower front as
shown. Make sure the Slide extends out perpendicular from
the play set.
Using the holes in the slide for guides, drill 5/16" diameter
holes through the Platform Boards and secure the Slide us-
ing 1/4" x 1" Truss Head Bolts from the top and 1/4" Weld
Nuts from below.
Note: Depending on the Slide, you may find the holes you
drill encounter a framing member. If so, stop drilling after
piercing the Deck Board. Loosen the Deck Board and insert
the Weld Nuts from the underside. If desired, a 1" spade drill
bit can be used to clear a space for the base of the Weld Nut
in the Framing Member. Re-attach the Platform Board and
continue securing the Slide.
1/4" x 1" Truss Head
Bolts with weld nuts
.
