Crane Voce Media, Technical Manual

Page: 101 / 116

Technical Manual 93
Se
cti
o
n
10
- D
ia
gn
o
stic
an
d
Ma
in
te
n
an
ce
P
ro
ce
d
u
re
s
A FRESH APPOACH TO VENDING
13. Re-assemble the wiper arm (d) to the filter holder
assembly.
Ensure that the wiper arm is located under the
coffee outlet pipes as shown (e).
14. Moving to the machine, remove the ‘O’ ring (a)
from the water inlet pipe and discard. Fit the ‘O’
ring included in the service kit onto the inlet pipe.
Ensure that the new ‘O’ ring is seated correctly.
Refit the CoEx® brewer unit into the machine.
Slide the unit into place until it ‘clicks’ into
position. Refit the coffee dispense pipe to the
brewer outlet.
10.5.2 Replacing the Grinder Blades.
1. Isolate the machine from the Mains power supply.
Push in the bean canister shut-off to close the
fresh beans outlet. Carefully remove the fresh
beans canister from the machine and place it to
one side.
Pull up and remove the grinder adjusting wheel
assembly (b) from the rear of the grinder body.
Unscrew the grinder body (c) anti-clockwise and
remove it from the blade housing.
Note: Grinder mechanism removed from the
machine for clarity.
2. Unscrew and remove the nut, star washer and
agitator (d) from the drive shaft.
Note: Nut is fitted with a left hand thread.
Remove the Grinder blade block (e) and discard.
Replace with the new grinder blade block included
with the service kit.
Refit the agitator, star washer and nut. Ensure that
the nut is tightened securely.
e
d
a
c
b
e
d