Crane Cafe VII, Setup Manual

Page: 31 / 84

6840070 Page 25
August, 2005
Café VII
®
Setup
SUPERVISOR MODE
Your machine is equipped with a special "Supervisor" mode. A supervisor is
allowed access to all programming functions without needing a carafe key. In
addition, the supervisor can prevent anyone without the supervisor code from
accessing any or all programming functions.
ENTER SUPERVISOR MODE
1. Make sure the door is open and the machine is in the "ready" mode (not
already in a programming function).
2. Press and . The display shows
`lab=J=J=J
.
NOTE
All machines have a factory default supervisor code of 000.
3. Enter your 3-digit code. You have 6 seconds to enter your supervisor code
before the screen goes back to the previous display. If you enter the wrong
code, the previous display is shown. If you successfully enter the code, the
display shows
prmbosfplo
one time. You can now access all programming
functions.
4. To leave Supervisor mode, shut the door.
VIEW OR CHANGE THE SUPERVISOR CODE
1. Enter the SUPERVISOR mode as instructed above.
2. Enter the CONFIGURATION mode by pressing and .
3. Press to advance through the selections until the display shows
`lab=uuu
. (XXX is the current Supervisor code number.)
4. Use the number keys to enter a new code number. Note that your new
number is followed by a decimal point. This decimal point will remain in
the display until you have "locked in" your new code. This helps to prevent
mistakes.
5. Press and to lock in the new code number. The decimal is
now gone from the display. If you don't lock in your new code number, the
old number is still active.