6840070
Page 61
August, 2005
Café VII
®
Setup
Press
, then
to rinse the brewer. The brewer closes, hot water
runs through the brewer, the pump and coffee whipper run, and the display
shows
ofkpfkd
, then returns to
_obt=ofk
.
Ingredient Chutes - Remove the chute(s), wash clean, and sanitize by rinsing
with hot water. Air dry before reinstalling.
Whippers and Impellers -
a.
Remove the whipper cover.
b.
Using the impeller removal tool (located in the plastic bag assembly),
remove the impeller from the whipper housing as shown.
c.
Wash the cover, impeller, and impeller housing. Sanitize with hot water
and allow to air dry before reassembling.
d.
To reassemble, see detail A. Note that the whipper motor shaft has a flat
section. Make sure this flat section lines up with the "D" shaped hole in
the impeller. Press the impeller all the way onto the whipper motor
shaft. Replace the cover.
NON FOOD-CONTACT PARTS
Brewer Mechanism Cleaning - Remove the brewer assembly to clean. See
CLEAN THE BREWER.
Exhaust Fan Filter - Remove the filter from its housing. Wash with soap and
water, rinse, wring dry, and replace into housing.
Grounds Pail - Empty and rinse the grounds pail.
Liquid Drain Tray - Empty, wash, and rinse with hot water. Sprinkle detergent
powder in the bottom of the tray to help control odors. You might want to save
this until last, because the waste water from rinsing the bowls and brewer will
collect here.
Summary of Contents for Cafe VII
