Crane BevMAX Refresh 4 3800-4, Operation Manual

Page: 11 / 62

Page 11 of 62
The Vender will support the following domestic MDB Bill Acceptors:
All available CPI/MEI/Mars MDB
All available Conlux MDB
All available Cashcode MDB
All available Coinco MDB
The Vender will support MDB Card Readers.
The Vender supports Swipe/Tap for Cashless Vending.
“Select then Pay” workflow for purchasing product is also implemented for both Cash and Cashless operations.
SETTING THE TEMPERATURE CONTROL
This Vender is equipped with an electronic Encapsulated Temperature Sensor. Defrost is controlled both
electronically based on run time of the compressor and with a manual Defrost Thermostat. The Temp Sensor is
factory pre-set to maintain a cabinet temperature of 35º Fahrenheit (1.7ºC). It is also a good practice to ensure
the proper operating temperature prior to installing the Vender on location. To check the temperature, apply
power to the Vender and allow it to run for several hours with the glass
door closed or until the minimum cabinet
temperature is achieved. The Display will show the temperature being reported by the temperature sensor.
The manual Defrost Thermostat is located in the bottom left of the service area. The Defrost Thermostat is preset
and is not adjustable.
LOADING THE VENDER
CAN/BOTTLE DRINK TRAYS
The BevMax 4 5800-4/3800-4 Vender does not require spacers or shims to vend most packages. Load product in
each column one package at a time insuring that the package being loaded is in front of the product pusher. Insure
that the package is stable within the column (doesn’t move excessively from side to side). After loading the
Vender, test vend each column to insure proper operation. Please contact a Service Representative or refer to
the proper Technical Publication for any special settings you may need.
LOADING COIN CHANGER TUBES
The Coin Changer tubes can be loaded using one of the following methods:
1. Load the Coin Changer with coins to the desired level by inserting coins in the loading slots on the coin
tube front.
Minimum coin tube levels are:
6-8 nickels
7-8 dimes
5-6 quarters
Note: A low coin level in the coin tubes will interfere with operation of the Bill Acceptor.
2. For exact cash accountability and to insure maximum dollar bill acceptance, load the Coin Changer utilizing
the coin insert slot on the front of the Vender while in the Tube Fill routine. Refer to the INITIAL
PROGRAMMING section of this guide for more information.
For additional information about Coin Mechanism, refer to the manufacturer’s instructions.