![background image](http://html1.mh-extra.com/html/cpi/cls-advance/cls-advance_operators-manual_2675010036.webp)
36
OM_CLS_-_EN_2-0
Service
CLS
Advance
8.4
Cleaning the CLS
This section describes the cleaning work that should be done by the operator as required depend-
ing on the installation site:
• Cleaning the housing and outer parts of the CLS
• Emptying and cleaning the dust tray
Please contact your service technician for further cleaning routines.
8.4.1
Cleaning the housing, coin input funnel and return tray
For cleaning work on the coin recycler please observe the following safety
instructions:
• Please only clean the components mentioned in this section. All other CLS
parts may only be cleaned by a qualified service technician.
• Pull out the machine’s mains plug when cleaning the CLS.
• Moisten cloths only slightly to prevent fluid from entering the device. This
would damage the PCBs and optics.
• Do not use solvents or scouring agents that could affect the surface of the
device.
• Do not reconnect the equipment if the connecting cables show any damages
or material fatigue (e.g. porous cables).
The surfaces of the coin input funnel (if necessary remove funnel insert
reinserting funnel insert", p. 35)
), return tray and the housing as well as the operating elements [
should be cleaned from time to time and as required depending on the installation site. For this,
use compressed air or a slightly moistened cleaning tissues.
Fig. 44:
Surfaces to be cleaned, if necessary remove funnel insert