C1
D1
E
D2
C2
7 MOUNTING IMPACT AWNING CANVAS
1 - 04.2014
CORRADI SpA - INSTALLATION MANUAL - pERGOTENDA®FLUX
39 di 53
fig. 59 – Mounting canvas on beams
Start by inserting the front terminal tube (
D1
) on the first slider (
C1
), then proceeding with all the other tubes excluding the last terminal on the motor side (
D2
).
Close the awning by moving the sliders already inserted nearer to the last fixed one (
C2
), only then mount the terminal tube (
D2
) on the slider (
C2
) and tighten the locking nut. Adjust the limit switches (see
chapter) and fit the closure covers (
E
).
NOTE
: The drive slider nuts (
C1
) and the fixed slider nut (
C2
) should be tightened until the terminal cap is against the slider.
The intermediate sliders should be hand-tightened to the end of the thread.
