17 di 53
CORRADI SpA - INSTALLATION MANUAL - pERGOTENDA®FLUX
1 - 04.2014
1
3
2
3 MOUNTING THE GUIDES/UPRIGHTS
fig. 17 - Assembling motor on runner cross-bar
The motor must be mounted on the runner cross-bar, where there are four screws, before the
cross-bar is positioned on the structure.
- partially unscrew two screws (
1
).
- completely unscrew the remaining screws (
2
).
- slide the motor plate until it is flush with the two screws on the runner cross-bar.
- tighten the remaining two screws to completely lock the motor.
Remove the screws on the runner cross-bar, fit the runner cross-bar with the motor facing the wall
to the beams with the screws previously loosened, positioning it so that the motor drive control
unit (
3
) is facing downwards.
fig. 18 - Mounting anti-torsion beam
Mount the anti-torsion beam (
1
), in correspondence with the motor, removing the screws pro-
vided (
2
) and fasten it to the angle bars (
3
) with the screws (
2
) previously loosened.
2
3
1
