32 of 109
CORRADI S.P.A. - USER MANUAL - EXYL
2 - 04.2011
PRODUCTS
FEATURES
PRODUCT FEATURES
NON COMPLIANCE/ DEFAULT
FALSE CEILING
In particular situations of use the structure may present condensation in the area between the canvas and the ceiling. This may
cause dirt and / or mold in the intermediate zone. Remove the false ceiling and wash it.
GUTTER
Periodically check that the drain pipes of the gutter and downspouts are clean. Discard leaves and other detritus that can clog
the drain holes.
In case of very heavy rainfall it is possible that the gutter is not able to drain the water. This may cause water infiltrations.
The water-conducting to the ground may not be controlled by Corradi SpA, but by the final customer. The installation conditions,
slopes and any collection wells, are the sole responsibility of the final customer.
LAMPS
To maintain good efficiency in the seals, thereby ensuring the IP product protection level (shown in the manual), you must do the
maintenance indicated in the manual.
AWNING SAILS
The presence of folds on the sail is due to the long winding of the sail on the roller tube. To limit this phenomenon and to have
the warranty the use of the sailcover is mandatory.
The presence of folds on the sail immediately after the first installation may be due to packaging. The folds will disappear com-
pletely after about 6 months of installation.
VELOMBRA FABRICS
The fabrics are "dyed in the piece", this can cause a non-perfect uniformity and consistency of color.
WOOD
WARNING: It is good to remember that any kind of wood type placed outside, and directly exposed to weather elements, may
look "lived" even after a relatively short period of time. This manifests itself mainly with:
• discoloration of the surface (the degradation varies depending on the moisture content to which the wood is subject)
• with the irregularity of the surface due to cyclic phenomena of swelling and shrinkage and possible mechanical wear of the
surface.
Since wood is a natural material, there are differences in color and grain and therefore all elements are different. Furthermore,
depending on the viewing angle the aspect is quite different because of the iridescent nature of the material. The samples and
photographic reproductions are thus regarded as indicative and not binding.
The detachment of a slat from the beams is considered a defect.
The wood is placed under a protective treatment performed in autoclaving which allows a better resistance to attack by fungus
and mold. This treatment is green (due to the salts used for impregnation), and is performed before painting the beams. The
appearance of green stripes on the wood as a result of leaching of the paint finish by bad weather is normal in case of bright
colors. In this case you must proceed with the maintenance as indicated in the manual.
The beams may present vertical stripes of different shades. This is normal and is due to stacking that occurs inside the autoclave
during the impregnation treatment (the beams are spaced apart by transverse beams).
The presence of resin is a characteristic of coniferous wood.
A dimensional variation of wood products after exposure to moisture is normal. The reference humidity for the measuring is 12%
(defined in the UNI EN390: 1997).
