Pinnacle 2 and 4 Flavor Service Manual
DC S
TATOR
A
SSEMBLY
R
EPLACEMENT
- B
ALDOR
1.
Disconnect the power to the unit. Remove back panel (4 screws) and side panels (3 screws each).
2.
Turn off the blendonator valve.
3.
Drain the cylinder of the faulty motor by opening the dispensing valve. When only CO
2
comes out, turn the
cylinder product supply valve off. Relieve CO
2
pressure by opening the faceplate pressure relief valve.
4.
Remove the cylinder face plate (4 nuts).
5.
Remove beater bar and scraper blades.
6.
Use the magnet puller tool (p/n 560003662) that comes with the unit to remove the magnet.
NOTE: Sufficient force must be used to break the magnet lose from the end of the cylinder.
CAUTION
— The magnet is very strong and heavy. Be careful not to pinch hands and fingers
between the magnet and a steel object.
WARNING
— Strong Magnetic Field.
Person wearing pacemaker, implanted cardioverter defibrillator, or other implanted medical device
may be effected by the magnetic field and must keep the magnet at 6 or more inches from the
device. The magnetic field can affect operation of these devices which may cause bodily injury or
death.
If disruption of device occurs or operation is adversely effected, immediately move the victim far away from
magnet and seek medical assistance.
7.
Disconnect product supply line. Disconnect wire harness. Remove foam insulation. Remove thermostat in
center of stator assembly. Unbend the index tabs and remove end cap.
FIGURE 65
8.
Remove stator assembly from cylinder (4 nuts).
9.
Apply silicon grease around the inside of the new stator and on the outside of the cylinder.
Be sure to put a new gasket in the cylinder inlet tube.
FIGURE 66
FIGURE 67
10. Slide new stator on end of cylinder. Torque nuts to 15-18 foot pounds. Replace end cap and bend index
tabs down. Replace thermostat, be careful not to over tighten the brass insert, the threads may snap off
inside the steel boss. Replace foam insulation. Reconnect wire harness. Reconnect product supply line.
Safety thermostat
Stator Assembly
Index tabs
Nuts (4)
Wire harnesses connector
Product supply line
Silicon
grease
inside of
stator
Silicon
grease
outside of
cylinder
© 2003-2014, Cornelius Inc.
- 52 -
Publication Number: 560007298SER
Summary of Contents for FCB - 2 Flavor
Page 75: ......
