CooperSurgical K-Systems L100 IVF Series, Instruction Manual

Page: 53 / 88

53
INSTRUCTION MANUAL FOR L100 SERIES WORKSTATIONS
8 CONNECTIONS
The L100 Workstations have connections on the back and inside.
8.1 Connectors on the Back
On the back of the workstation there are 8 circuit fuses, a main connector, a main switch, a mains fuse,
and the gas inlet.
In the following sub-sections, the connectors are explained in more detail.
8.1.1 Circuit Fuses
This equipment is protected by fuses. The fuse ratings are printed on the label attached next
to each fuse holder (See Section 10: Fuses).
NOTE:
Note that some of the fuse holders may be empty due to various configuration possibilities. Only
replace with same type fuse.
8.1.2 Mains Connection
Mains are connected with the cable supplied with the unit. If this is not present or does not fit, contact
your local Service Representative. Do not use a non-original cable, this could be dangerous
and will void the warranty.
Before connecting the mains, check the markings on the side of the workstation and verify that the yellow
mains label reflects the correct voltage.
When marked 220-240V AC, the workstation can be connected to mains in the range of 220-240V AC
50 Hz.
If the markings correspond with the local mains power the unit can be connected
and switched ON.