07
INSTALLATION PROCESS AND CONSIDERATIONS:
• Two 50mm class 9 or class 12 PVC pipes are required as balance lines from the project’s
wall to the pump and filter area. One pipe is for the sensor and the second is required
for the fill line back to the pool.
ALWAYS USE 50MM PIPE FOR THE SENSOR
HOUSING TO ENABLE ADEQUATE FLOW AROUND THE SENSOR AND FUTURE
SERVICABILITY.
•
THESE PIPES MUST BE PLACED AT LEAST 300MM BELOW WATER LEVEL
and can
be dressed with push-in eyeballs to match the project’s other wall fittings.
• The pipes are usually run along the suction and return trench and elbowed up within
the equipment area.
THESE PIPES MUST BE LEVEL TO AVOID AIR LOCKS
which will
affect flow and performance.
• A 50mm cap is provided to cover the sensor pipe housing and protect the Sensor
from dust, debris, pests and foreign materials. The cap fits neatly onto the 50mm
sensor pipe housing.
•
DO NOT GLUE THE CAP TO THE SENSOR HOUSING PIPE.
• If the Sensor is to be located away from the equipment area,
ALWAYS RUN THE LEAD
THROUGH ADEQUATELY SIZED CONDUIT THAT WILL ENABLE THE COMPLETE
SENSOR TO BE REPLACED AT A LATER DATE.
•
NEVER CUT EXCESS SENSOR CABLE.
Roll excess cable and bind together with the
Velcro straps provided.
•
INSERT THE SENSOR PLUG
INTO THE CORRECT PORT
ON THE CONTROL BOX AS
INDICATED ON THE LABEL.
