CONVEY-ALL CST-1634, Operator'S Manual

Page: 43 / 50

01.2016 5-1
Operator’s Manual: Commercial Seed Tender (CST-34 Series)
Section 5: TROUBLE SHOOTING
In the following trouble shooting section, we have listed many of the problems, causes and solutions to the problems
which you may encounter.
If you encounter a problem that is difficult to solve, even after having read through this trouble shooting section,
please contact your authorized dealer, distributor or the factory. Before you call, please have this Operator’s Manual
and the serial number from your machine ready.
Problem
Possible Cause Possible Solution
Engine/Motor labouring
Belt is sticky on the back side, because of oily
product or wet/snowy conditions
Clean the belt
Hopper flashing too tight Adjust to loosen the flashing
Air cleaner dirty, if equipped Clean the air cleaner, and/or replace the air filter
Belt not turning
Hopper flashing may be stuck to belt, because it is
running dry and rubber is heating up
Turn off unit! Manually peel flashing up and off hopper.
Then run dry product through to create barrier between
flashing and belt
Belt doesn’t track correctly
Roller lagging may be worn Replace roller or have it relagged
Product leakage
Product may be getting under the belt at the
hopper, traveling up inside the belt and leaking off
delivery end
Replace hopper flashing
Conveyor won’t run
No power Start engine, increase speed to maximum RPM