CONVEY-ALL CST-1634, Operator'S Manual

Page: 32 / 50

Operator’s Manual: Commercial Seed Tender (CST-34 Series)
4-2 01.2016
4.1.1 Greasing
Use the Service Record provided on page 4-11 to
keep a record of all scheduled maintenance.
1. Use only a hand-held grease gun for all greasing.
An air-powered greasing system can damage the
seals on bearings and lead to early failures.
2. Wipe grease fitting with a clean cloth before
greasing to avoid injecting dirt and grit.
3. All bearings are sealed and greasable. They
require minimal lubricant.
Recommended greasing is 1 small stroke every 2
weeks. Be careful not to over-grease, as this may
push the seal out.
4. Replace and repair broken fittings immediately.
5. If fittings will not take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
4.2 SERVICING INTERVALS
The periods recommended below are based on
normal operating conditions. Sever or unusual
conditions may require more frequent servicing.
Schedules may vary depending on equipment options
and engine model contained in the present unit.
The conveyor belt alignment is preset to run true
under a condition of no load. It is important to check
alignment and make adjustments, if required, during
the initial few minutes of operation.
Check bearing for wear daily.
4.2.1 Every 10 Hours or Daily:
If Equipped with Self-Contained Hydraulic Pack:
1. Check fuel level.
2. Check engine oil level.
3. Clean air filter
4. Check hydraulic oil level.
36-2200-0001