21
CONVAID USER’S GUIDE
Seat Back Angle Adjustment
Cruiser seat back angle can be adjusted in 5 degrees
increments from 85~95 degrees relative to the seat base
angle. These adjustments can be performed without
hand tools by following the directions below. Fig.59
95°
90°
85°
J-bolts
Seatbelt
Knob Washer Coved
Washer
85°
90°
95°
Fig. 59
Fig. 60
Fig. 61
Fig. 63
Fig. 62
1. Turn knob on inner seat back tube count-
er-clockwise to fully remove from J-bolt.
Fig.60
2. Keep track of the all hardware position (cov-
ed washers, Seatbelt brackets and closure
straps) for re-assembly.Fig.60
3. Remove J-bolt from seat tube and catch all
hardware that may fall out in the process.
4. Install J-bolt into desire seat back angle
position with proper hardware. Fig.61,63
5. Reinstall all hardware (coved washers, seat-
belt brackets and closure straps) to proper
position. Fig.60
6. Insert the head of J-bolts into unused re-
maining holes to lock bolt in place. Fig.61,63
7. Reinstall knob and apply blue Loctite onto
the treads of the J-bolt and hand tighten
knob. Fig.62
8. Repeat same steps above for the other seat
back tube and both seat back tubes must be
to set to the same angle.
WARNING:
Check knob regularly to ensure
tightness as it may come loose during use.
WARNING:
Remove user prior to adjusting the
seat back angle
