Description of application and parameters
Application program
37
Options:
Maximum
High
Medium
Low
Off
–
Maximum
: Even higher sensitivity than standard
– increase in transmission range.
–
High
: As standard intended for indoor use.
–
Medium
: To be used when there are small interfering heat sources within the detection area.
–
Low
: To be used when there are large interfering heat sources within the detection area.
–
Off
: The sensor is switched off and movement is no longer detected in this area.
NOTE
The transmission range can
not
be changed via the sensitivity.
Options:
No
Yes
–
No
: There is no object with which the detector can be blocked or enabled.
–
Yes
: A 1-bit enable movement communication object (input) is being enabled. This object
allows the detector to be enabled or blocked. No telegrams are sent by the detector during
blockage.
NOTE
This parameter is only visible if the "Use of enable detector object" parameter is
set on "Yes".
Options:
ON telegram
OFF telegram
–
ON telegram
: With the receipt of value 1 on the enable movement (input) object the detector
is enabled and blocked with value 0.
–
OFF telegram
: With the receipt of value 0 on the enable movement (input) object the
detector is enabled and blocked with value 1.
