Contrec 515 BR03, Operation Manual

Page: 19 / 110

9
Chapter 3
Installation & Maintenance
Installation Instructions
The safety of any system incorporating the equipment is the responsibility
of the assembler of the system and should be installed such that there is no
risk of impact damage.
This instrument is intended for fixed installation only, e.g. within a panel or
cabinet, and is not intended for desktop use. It is not suitable for outdoor use
unless fitted into an appropriate outdoor enclosure with a minimum type 3,
IP54, rating. The instrument has a ‘Pollution degree II’ rating.
Cleaning and Decontamination
For general maintenance or to clean an instrument suitable for return to a
service centre for repair or inspection, use only a damp cloth and mild
detergent. Do not use abrasive cleaners or high pressure water jets. An
instrument must be decontaminated before returning. The marking label can
be cleaned with 35% Isopropanol or mild detergent.
Panel Mounting
The instrument should be located in an area with a clean, dry atmosphere
that is also relatively free of shock and vibration.
The standard mounting procedure is panel mounting in a cutout that is
139 mm wide by 67 mm high. Two side clips secure the unit into the panel.
Figure 2 shows the panel mounting requirements for the 515 instrument.
Figure 2 500 Series Instrument Panel Mounting
145 mm
Side View
22 mm
70 mm
67 mm
139 mm
25 mm
66
mm
Min. 189 mm
Panel Cut-out
Front
Panel
74
mm
Mounting Clip
138 mm
147 mm
Rear Connectors
Top View
RS232
Port
515 BR03 - 15 August 2021