Contax SW 2524, Owner'S Manual, Page: 244 / 322

Troubleshooting
9–4 976-0043-01-01
Battery Charger Troubleshooting
If the red ERROR LED comes illuminates the control module, see “05
Error Causes Menu” on page 8–25 to determine the cause of the error
condition. Then use the solutions below to resolve the situation.
Problem Possible Cause Solution
AC1 LED is flashing,
but will not start
charging
(allow 40 seconds to
synchronize). Battery voltage is below
the
22B Low Xfer (BX)
VDC setting.
You are outside of the
21 Grid Usage timer
period.
Check for the correct AC voltage or frequency at the
AC input terminal. If it is normal:
1) Check to see if the BX mode is enabled. The AC
input is not allowed to synchronize and pass-
through unless the battery voltage reaches the
22B Low Xfer (BX) VDC setting.
2) Check to see if the 21 Grid Usage timer (21B
and 21C) is enabled and that you are outside of the
21 Grid Usage timer period. The AC is not allowed
to synchronize and charge unless you are within the
21 Grid Usage timer period.
AC1 or AC2 LED is
flashing, but will not
start charging
(allow 40 seconds to
synchronize). AC frequency at the AC
input terminal may be
out-of-tolerance (too
high or low) or the AC
voltage may be outside
the
13C Input Upper
Limit VAC or 13D
Input Lower Limit
VAC
settings.
Check for the correct AC voltage or frequency at the
AC input terminal. If the AC source is a generator,
adjust the AC voltage or frequency accordingly.
AC1 or AC2 LED is
flashing and repeatedly
connects and
disconnects to the
source. AC frequency at the AC
input terminal may be
out-of-tolerance (too
high or low) or the AC
voltage may be outside
the
13C Input Upper
Limit VAC or 13D
Input Lower Limit
VAC
settings.
Or the inverter circuit
breaker has opened.
Check for the correct AC voltage or frequency at the
AC input terminal. If the AC source is a generator,
adjust the AC voltage or frequency accordingly.
If the circuit breaker is open, press it back in to reset
it.
If circuit breaker on the inverter is not open, the
inverter may need to be serviced.