Contax SW 2524, Owner'S Manual, Page: 212 / 322

Operation
8–4 976-0043-01-01
Inverter Operation Status (Yellow)
There are two yellow LEDs to indicate the following inverter operational
modes.
•
GRID TIE LED - This feature is not available at this time.
• INVERT LED
GRID TIE LED This feature is not enabled on this model. Therefore, this LED will not be
illuminated during normal operation. It might, however, flash during
initial startup or during an LED test.
INVERT LED This LED indicates the inverter is operational and inverter power to the
AC output is available to power the load if needed. Therefore, this LED
will be illuminated during normal operation.
Search Mode Indication If the INVERT LED is blinking and no other
LEDs are illuminated, the inverter is in the energy saving SEARCH Mode
and monitoring the output for a load greater than the
01C and 11E Search
Watts setting.
Standby Mode Indication If the INVERT LED blinks and the AC1 or
AC2 LEDs are illuminated, the inverter is in Standby Mode and is ready
to engage and provide power if the AC source is lost.
Figure 8-2 Inverter Operation Status LEDs